Properly aligned EPDM (Ethylene Propylene Diem Monomer) adhesive-backed gasketing shoulders against an extruded slot which prevents hardware from damaging the gasketing and violating the seal integrity.
|
Screened breather/drains are provided at all access covers, elbows and along enclosure bottoms to minimize the formation of condensation. Strip heaters are located in proximity to access covers to allow easy inspection. Heater wiring is contained in a factory installed and terminated flexible metallic conduit. Heaters are operated at half voltage for extended life. |
| A complete selection of column support structures, wall supports and duct suspension assemblies are a part of every bus system design project and are ultimately dictated by individual site parameters. Experienced TECHNIBUS designers are available to assist you in putting together a system which meets your site-specific needs. | Structural supports are designed in accordance with the American Institute of Steel Construction. Supports are designed for nominal 12 to 15 foot spacing and are adjustable to accommodate site variations. Supports are clamped to ducts which eliminate installation alignment problems and field drilling. |
1501 Raff Rd. SW 
Canton, Ohio 44710 Fax:
330-478-8377
